Filter
Top Products
6
Step 1:
Connections
Ceiling speakers, etc. are used for maximizing effects in Dolby
Atmos or Dolby Surround listening mode. Install Top Front
speakers midway between the position just above the listening
position and the position just above the front speakers. Install Top
Middle speakers just above the listening position. Install Top Rear
speakers midway between the position just above the listening
position and the position just above the surround back speakers.
Combination patterns for Height speakers 1 and 2
Dolby recommends the following combination pattern
to obtain the best effect of Dolby Atmos and Dolby
Surround listening modes.
r Pair 1: Top Middle
r Pair 2: Top Front / Top Rear
The following are the patterns of Height speakers 2 that
can be selected according to the type of Height speakers 1.
Height speakers1: Front High
Height speakers2: Not Use/Top Middle/Rear High/Dolby
Enabled Speaker (Surround)/Dolby Enabled Speaker (Back)
Height speakers1: Top Front
Height speakers2: Not Use/Top Rear
Height speakers1: Top Middle
Height speakers 2 cannot be used.
Height speakers1:
Dolby Enabled Speaker (Front)
Height speakers2: Not Use/Dolby Enabled Speaker
(Surround)/Dolby Enabled Speaker (Back)
Height speakers1: Dolby Enabled Speaker (Surround)
Height speakers 2 cannot be used.
Height speakers1:
Dolby Enabled Speaker (Back)
Height speakers 2 cannot be used.
r When front speakers are bi-amp connected, you can select
a pattern for Height speakers 2 from the following options.
Not Use/Front High/Top Front/Top Middle/Dolby Enabled
Speaker (Front)/Dolby Enabled Speaker (Surround)/Dolby
Enabled Speaker (Back)
Notes for speaker connection
This unit works as an AV controller when connected with
a separately sold multichannel power amplifier. Connect
a power amplifier to the PRE OUT RCA jack or PRE
OUT XLR jack of the unit and then connect speakers to
the speaker terminals of the power amplifier. For how to
connect the power amplifier with speakers, refer to the
instruction manual of the multichannel power amplifier.
r Set the crossover frequency, speaker distance and other
speaker settings on this unit.
Connecting the multichannel power amplifier
to the PRE OUT RCA jack
Connect the multichannel power amplifier to the PRE OUT
RCA jack. Connect the unit and power amplifier with an
RCA cable.
$
Center
H
Height2 R/
J
Wide R
G
Height2 L/
I
Wide L
#
Front R
&
Surround R
F
Height1 R
"
Front L
7
Surround
back L
8
Surround
back R
%
Surround L
9
Height1 L
PUSHPUSH
P
USHPUS
H
RCA cable