Filter
Top Products
SETUP MENU OPTIONS
46
Audio Setup Page
EQ Type
Sound Field
Digital Outupt
LPCM Rate
Audio Tone
Pro Logic II
Dolby Digital Setup
HDMI Audio
-- Audio Setup Page --
None
Off
Raw
48K
00
Auto
1. EQ Type: To set the equalization pattern type. Available options are: None, Rock, Pop, Live,
Dance, Techno, Classic and Soft.
2. Sound Field: To set the sound field effect. Available options are: Off, Concert, Living Room,
Hall, Bathroom, Cave, Arena and Church.
3. Digital Output: To set the bit stream type of the digital audio output for use with Dolby Digital
and DTS-compatible receivers. The options are:
• Raw – Passes the encoded multi-channel digital audio unaltered. Choose this setting if
your receiver/amplifier is capable of decoding Dolby Digital and/or DTS.
• PCM – Forces down-mixed 2-channel digital audio output. Choose this setting if your
receiver/amplifier only supports stereo digital (PCM) audio.
4. LPCM Rate: To set the maximum Linear PCM output frequency. The options are:
• 48K – Supported by most equipment.
• 96K – Allows a higher sampling rate and frequency response. It can result in better audio
quality. Ensure that the receiver/amplifier can support it.
• 192K – Allows the highest sampling rate and frequency response. It can result in the best
audio quality. Ensure that the receiver/amplifier can support it.
5. Audio Tone (+/-16): This function raises or lowers the tone (key/pitch) of the audio track. This
is useful for playing Karaoke discs and should not be used for regular music listening or movies.
• Press the SELECT button to show the tone control window.
• Press the left/right ARROW buttons to lower or raise the tone/pitch.
• Press the SELECT button to confirm the setting.
6. Pro Logic II: Taking a step further than most DVD players, the OPPO DVD player allows you to
configure Dolby Pro Logic II to expand 2-channel source audio into full 5-channel surround
sound. Note: Pro Logic II functionality is effective only when Speaker Setup Page > Down-
mix is set to “5.1ch” and Digital Output is set to “Raw”.
• Press the SELECT button to enter the “Pro Logic II Config” page.
• Press the left ARROW button to exit the “Pro Logic II Config” page.