Filter
Top Products
24
2
Upon completion of the editing, press the REVIEW
button.
Review is then started by the recorder side.
OTo stop the review at any time, press the STOP
button.
OWhen the edit OUT point is reached, the tape is
post-rolled, after which it stops.
1
Press the AUTO EDIT button.
Automatic editing is now executed.
OTo suspend editing at any time, press the STOP
button.
OWhen the edit OUT point is reached, the tape is
post-rolled, after which it stops.
Post-rolling
With assemble editing, editing continues for about
2 seconds after the edit OUT point is passed, the
tape is then returned to the OUT point, after which
it stops.
With insert editing, the PLAY mode is established
after the edit OUT point has been passed, the tape
is then returned to the OUT point, after which it
stops.
The post-roll time can be set using setup menu No.
325 (POSTROLL TM).
Retry function
Even when the STOP button has been pressed to
suspend editing, editing can be repeated from the
beginning simply by pressing the AUTO EDIT
button again.
Auto tag function (recorder side)
If, upon completion of editing, the next edit point
has not yet been registered, the previous edit OUT
point is registered as the IN point and editing is
executed when the AUTO EDIT button is pressed.
To release the auto tag mode, press one of the
transport system buttons (such as the PLAY
button).
Registering an OUT point while editing is in
progress
If the SET button is pressed while the OUT button
is being held down when automatic editing is in
progress, the position corresponding to when the
button was pressed is registered as the OUT point
and the editing operation is exited.
Even if the AUTO EDIT button is pressed, the OUT
point is registered and editing is exited in the same
way.
<Note>
The registered points are automatically cleared
after editing has been executed. However, the
previous edit points can be recalled by pressing
the TRIM+ (or TRIM–) button and SET button at
the same time.
Executing and reviewing automatic
editing