Filter
Top Products
41
RS-232C
(4) Command list
$
List of commands
The table below lists the send commands and operations for each mode as seen from the computer end.
[STX] = HEX code 02H
[ETX] = HEX code 03H
: = HEX code 3AH
The discrimination part and data part represent the ASCII codes which support the corresponding
symbols.
O
Audio control commands
Sends data of computer Return data from VTR Description of command
[STX] AOC:m [ETX] [STX] AOC [ETX] Sets the audio signal output channel.
O
Counter control commands
Sends data of computer Return data from VTR Description of command
[STX] CCP:data [ETX] [STX] CCP [ETX] Presets the CTL counter data (same as CLP).
[STX] CDF [ETX] [STX] CDF [ETX] Cancels the drop frame mode setting.
[STX] CDN [ETX] [STX] CDN [ETX] Makes the drop frame mode setting valid.
[STX] CHM:m [ETX] [STX] CHM [ETX] Sets 12-/24-hour mode for the CTL display.
[STX] CLP:data [ETX] [STX] CLP [ETX] Presets the CTL counter data (same as CCP).
[STX] CRN:m [ETX] [STX] CRN [ETX]
Sets the signal to be regenerated when TCG is in
regeneration mode.
[STX] CRR [ETX] [STX] CRR [ETX] Uses the TCG in the REC RUN mode.
[STX] CRT [ETX] [STX] CRT [ETX] Resets the CTL counter data.
[STX] CTC [ETX] [STX] CTC [ETX]
Sets the mode in which time code data is to be used for the
counter value.
[STX] CTF [ETX] [STX] CTF [ETX] Uses the TCG in the FREE RUN mode.
[STX] CTL [ETX] [STX] CTL [ETX]
Sets the mode in which CTL data is to be used for the
counter value.
[STX] CTM:m [ETX] [STX] CTM [ETX] Sets the TCG operation mode.
[STX] CTP [ETX] [STX] CTP [ETX] Uses the TCG in the preset mode.
[STX] CTR [ETX] [STX] CTR [ETX] Uses the TCG in the regeneration mode.
[STX] CTS:data [ETX] [STX] CTS [ETX] Presets the TCG data.
[STX] CUS:data [ETX] [STX] CUS [ETX] Presets the user’s bit data.
[STX] CVP:data [ETX] [STX] CVP [ETX] Specifies the line where the external VITC is to be inserted.