Filter
Top Products
49
[STX] CTP [ETX] [STX] CTP [ETX] Uses the TCG in the preset mode.
The TCG starts counting up in the REC RUN mode upon
completion of the settings.
<Note>
This command is ignored while a search control command
is being processed, during recording and in the INSERT
mode.
[STX] CTR [ETX] [STX] CTR [ETX] Uses the TCG in the regeneration mode.
<Note>
This command is ignored while a search control command
is being processed, during recording and in the INSERT
mode.
RS-232C
$
Counter control commands
Sends data of computer Return data from VTR Description of command
[STX] CTS:data [ETX]
Parameters
data = hhmmssff
hh = 00 23: Hours
mm = 00 59: Minutes
ss = 00 59: Seconds
ff = 00 29: Frames
[STX] CTS [ETX] Presets the TCG data.
The value will be corrected as follows if the non-drop frame
preset value has been set while the drop frame mode is
established.
00:01:00:00
00:00:59:28
00:01:00:01 00:00:59:29
Error code ER001 is returned from the VTR when the TCG
is used in the regeneration mode or external VITC mode.
<Note>
This command is ignored while a search control command
is being processed.
[STX] CUS:data [ETX]
Parameters
data = U
7
U
6
U
5
U
4
U
7
U
3
U
2
U
1
U
0
The input user bit data is set in
ASCII code.
UB data: Binary 4BIT
a
8
ASCII code: 0 9, A F
[STX] CUS [ETX] Presets the user’s bit data in the TCG.
Error code ER001 is returned from the VTR when the TCG
is used in the regeneration mode or external VITC mode.
<Note>
This command is ignored while a search control command
is being processed.
[STX] CVP:data [ETX]
Parameters
data = ppqq
pp = 10
20: Insertion line 1
qq = 10 20: Insertion line 2
pp ≠ qq
(the same value cannot be
designated for both pp and qq)
[STX] CVP [ETX] Specifies two lines where the external VITC signal is to be
inserted.
<Note>
This command is ignored while a search control command
is being processed, during recording and in the INSERT
mode.
$
Display control commands
Sends data of computer Return data from VTR Description of command
[STX] DFC:m [ETX]
Parameters
m = C: CTL mode
T: TC mode
U: UB mode
R: REMAIN mode
[STX] DFC [ETX] Sets the display mode of the counter display and the
reference data for searching.
CTL data reference:
CTL mode
TC data reference:
TC mode, UB mode, REMAIN mode
<Note>
This command is ignored while a search control command
is being processed.