Filter
Top Products
– 87 –
TC/CHR CONVERT menu
Key
F12
F13
Key designation
HD SUPER
LTC OUT°
Description
For selecting the time code which is to be output to the HD
monitor connector.
24TC: The original time code with the frame count of 24 is
output.
30TC: The post-conversion time code with the frame count of
30 is output.
(25TC
): The post-conversion time code with the frame count of
25 is output.
For selecting the time code which is to be output to the LTC
output connector. (For details, refer to page 90.)
(25TC
): This item appears only when the 25/50 Hz has been
selected as the system frequency.
30TC: The post-conversion time code with the frame count of
30 is output.
24TC: The time code with the frame count of 24 is output.
°This item appears only when the 1080/23p, 1080/24p, 1080/50p or 1080/50i system format is used. When 30TC is
selected as the setting, the continuity of the time code is guaranteed only in the 1t tape travel servo lock status.
Bear in mind that the time code will be discontinuous at all other times.
F13
F12
F11
F10
F9
F8F7F6F5F4F3F2F1
EJT CTL
RESET
FREEZE
OFF
OUTPUT TC/UBTC/CTL TC CLR
RESET
TC HOLD
HOLD SETUP
FREE
REC INH
RC 30SYS
EE TCTC
8
∑ Concerning the TC SYNC value and sync phase settings
Since the TC is similarly converted when the 1080/23psf (p) or 1080/24psf (p) format is converted into the
1080/59i (480/59i) or 1080/60i format, it is necessary to input the time information (TC SYNC value) that will
serve as the reference for conversion and the 3:2 pull-down sequence (sync phase) of the post-conversion
output images.
∑ Setting the TC SYNC value
Input the pre-conversion TC with the frame count of 24 (24TC) and the post-conversion TC with the frame
count of 30 (30TC)/25 (25TC) to serve as the reference for conversion.
ONoteN
When converting from 1080/25psf to 1080/23psf to 1080/59i (480/59i), or from 1080/25psf to 1080/24psf
to 1080/60i
Input the pre-conversion 25-frame count TC (25TC) value that will serve as the reference during conversion
and the post-conversion 24/30-frame count TC (24TC)/(30TC) value. SYNC PHASE is valid during the 24TC
to 30TC conversion.
When the audio insert editing status has been established by selecting ON as the setting for the F6
(RC_30SYS) key and 30TC for the F10 (RC_TC) key, will appear at the top right of the HOME
menu and MANUAL EDIT menu, as shown below.
RC 30SYS