Filter
Top Products
TV screen
The picture with interference
On-Screen Display
Test pattern indication
Removing Interference / Changing RF-channel
In some cases, interference (lines or patterning) or a very poor picture may
appear on the TV when the VCR/DVD is connected. If this happens, follow the
steps below to change the video playback channel (RF output channel) to
remove the interference.
!
Set the switch to VCR.VCR/TV/DVD
!
Press the button for more than 5 seconds.MENU The RF
output channel number is displayed on the VCR display.
VCR Ch:28
The clear picture
!
Press to finish this setting.ENTER
!
Press the buttons or use the Channel buttonNumeric (CH)
to select a channel number, which differs by 2 or 3 from the
present channel number. (For example, if the original
channel number was 28, enter 31.)
- Set the RF output channel of the VCR to [- -] (RF OFF) if the VCR
is connected to the TV via the 21-pin Scart cable.
- Press the button or Channel button to display [- -], if
using a 21-pin Scart cable.
0
21
68
(RF OFF)
...
!
Retune your TV until you receive the Test pattern. It may be
necessary to repeat steps 2 and 3 above until you can see the
Test pattern clearly. If using a Scart cable please see the note
below.
VCR display
Indication when the RF output
channel is 28 (example)
Indication afterchanging the RF
output channel to 31 (example)
Test pattern indication
VCR Ch:31
Notes:
DVD
TV
VCR
MENU
123
4
5
789
0
6
10
CH
TRACKING/V-LOCK
19
VCR DVD