Filter
Top Products
10
Installation
Cable connection
Connect the cable wire to the CABLE IN jack on the rear panel of the Digital CATV Terminal.
Incoming signal from the Cable Service Provider
Digital CATV Terminal connection to stereo TV and stereo VCR
Follow this diagram when connecting the Digital CATV Terminal to a stereo TV and stereo VCR.
VCR or S-VCR
TV or S-VCR
TV
Procedure
1 Connect S-VIDEO Cable from the S-VIDEO output jack on the Digital CATV Terminal to the S-VIDEO input jack on
the TV or S-VCR.
Note: Connect either the S-VIDEO or video input/output as shown above.
S-VIDEO will provide better picture quallity.
2 Connect audio cables from the left and right audio output jacks on the Digital CATV Terminal to the left and right
audio input jacks on the TV or VCR (S-VCR).
Note:
Additional equipment and cables shown are not supplied with this set.
Unplug the AC power cord and disconnect
all cables attached to the Digital CATV Termi-
nal.