Filter
Top Products
7
Installation
Check the accessories before installations.
•
Operating Instruction book
(TQBC0360/0361/0362)
•
Remote Control Transmitter
(TNQE284)
•
Battery for the Remote Control
Transmitter
(2 × AAA size)
POWER
EJECTDISPALY
T
O
P
M
E
N
U
ANGLE
D
V
D
M
E
N
U
ENTER
TV
MENU
RETURN
SKIP
SLOW/SEARCH
STOP
PAUSE PLAY
ASPECT
TV/VIDEOMUTE
SLEEP
CH
VOL
SURROUND
CANCEL
REPEAT MODEA-B REPEATPLAY MODE
R-TUNE
•
AC Adaptor & AC Cord
AC Adaptor: (N0JZHK000005)
AC Cord: (K2CA2EA00005)
•
Warranty Card
(TQDC18014/18016)
•
Service Center List
(TQBC7055-2)
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will
damage the remote control transmitter.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new
batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when the remote control acts
sporadically or stops operating this unit.
Helpful Hint:
For frequent remote control
users, replace old batteries with
Alkaline batteries for longer life.
Remote control battery installation
Requires two AAA batteries.
1. Turn the transmitter face down.
Remove top cover by pressing
down on marking and sliding
cover off in the direction indicated.
2. Install the batteries as shown in
the battery compartment. (Polarity
+ or – must match the markings in
the compartment).
3. Replace the cover and slide in
reverse until the lock snaps.
SUPPLIED ACCESSORIES
2 × AAA
size
•
Cable Cover: (TKKL5212)
•
Cable Clamp: (TMME088)