Filter
Top Products
9
Use this configuration when connecting the TV to a cable TV system using a Cable Box and VCR.
OUTPUT
S-VIDEO
VIDEO
L-AUDIO-R
OUTPUT INPUT
ANT OUTPUT
ANT INPUT
Connect the cable from
the Output terminal on
the back of the VCR to
the Antenna input
terminal on the left side
of the TV.
Connect the cable from the
Output terminal on the back
of the Cable Box to the
Antenna input terminal on the
back of the VCR.
ANTENNA
TERMINALS ON
THE LEFT SIDE
OF THE TV
VCR
CABLE BOX
TERMINAL ON THE BACK
OF THE CABLE BOX
Incoming Cable from
Antenna or Cable TV
System
TO VCR
Connect the cable from the
antenna or cable system to the
Input terminal on the back of the
CABLE BOX.
Installation
Note: When the antenna cable is connected to the TV antenna terminal via a cable box or VCR, set the TV channel
to CH3 or CH4, cable. This does not apply when signal is input from VIDEO INPUT.
Antenna Connection (Cable Box, and VCR)
Removing stand cover
Wall
Floor
Example of
Wall-Mount Installation
1. Removing the Stand Cover
Release the lock in the
lower center of the stand
cover.
Slowly pull the cover
downward.
Installation Option
Wall-mount bracket (model No.: TY-WK15TA2U)
If you require further information, contact the dealer where you purchased this product.
Installing / Removing the Stand Cover
• The optional wall-mount bracket can be installed only after
the TV stand is removed. Follow the instructions below to
remove the stand cover.
• Once wall mount has been mounted, replace stand cover.
• For detailed TV stand installation/removal steps, refer to
the installation manual for the wall-mount bracket
(optional).
2. Installing the Stand Cover
Insert the 3 upper claws
of the stand cover into
the mating slots.
Press in the lower center
of the stand cover.
Installation Options
Installing on a Wall
• For reasons of performance and safety, installation using the optional wall-mount
bracket should only be attempted by a qualified installer.
• Keep the Installation Manual and all the removed parts in a safe place for future use.