Filter
Top Products
[PROJECTOR SETUP] menu
ENGLISH - 111
Settings
■
To adjust the date and time
manually
4) Select [ADJUST CLOCK] in Step 3).
5) Press the <ENTER> button.
z
The [ADJUST CLOCK] screen is displayed.
6) Press
to select an item, and press
to set the local date and time.
7) Press
to select [APPLY], and
press the <ENTER> button.
z
The setting of the time will be completed.
■
To adjust the date and time
automatically
4) Select [ADJUST CLOCK] in Step 3).
5) Press the <ENTER> button.
z
The [ADJUST CLOCK] screen is displayed.
6) Press
to select [NTP
SYNCHRONIZATION], and press
to change the setting to [ON].
z
The setting will change as follows each time
you press the button.
[OFF] [ON]
7) Press
to select [APPLY], and
press the <ENTER> button.
z
The setting of the time will be completed.
Note
z
To set the date and time automatically, the projector
must be connected to the network.
z
If synchronization with the NTP server fails
just after [NTP SYNCHRONIZATION] is turned
[ON], or if [NTP SYNCHRONIZATION] is turned
[ON] while the NTP server is not set, [NTP
SYNCHRONIZATION] will return to [OFF].
z
Access the projector via a web browser to set the
NTP server. (
page 134)
[LENS CALIBRATION]
Automatically set the lens shift limit values and home
position for the projector.
1) Press
to select [LENS
CALIBRATION].
2) Press the <ENTER> button.
z
A conrmation message is displayed.
3) Press
to select [OK], and press
the <ENTER> button.
z
To cancel, select [CANCEL].
z
The lens moves up, down, left and right to
automatically set the lens shift limit values and
home position.
z
The lens stops to complete the calibration.
Note
z
[PROGRESS] is displayed on the menu during lens
calibration. Cannot cancel mid-operation.
z
When lens calibration executes correctly,
[COMPLETE] is displayed and [INCOMPLETE] is
displayed when it does not execute correctly.