Filter
Top Products
Switching on/off the projector
ENGLISH - 49
Basic Operation
Power indicator
The power indicator displays the status of the power. Check the status of the power indicator <ON (G)/STANDBY
(R)> before operating the projector.
Power indicator <ON (G)/STANDBY (R)>
Indicator status Status
No illumination or ashing The main power is switched off.
Red Lit
The power is switched off. (Standby mode.)
Projection will start if the power on <
> button is pressed.
z
The projector may not operate when the lamp indicators
<LAMP1>/<LAMP2>/<LAMP3>/<LAMP4> or temperature indicator
<TEMP> is ashing (
page 142).
Green Lit Projecting.
Orange Lit
The projector is preparing to switch off the power.
The power is switched off after a while. (Changes to the standby
mode.)
Note
z
In about 75 seconds after the projector is switched off and the luminous lamp cooling is started, the lamp
indicators will not light up even if the power is switched on. After the power indicator <ON (G)/STANDBY (R)>
lights in red, turn on the power again.
z
The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lit in red).
Refer to “Power consumption” (
page 172) for the power consumption.
z
The power indicator <ON (G)/STANDBY (R)> will ash in green if a remote control signal is received.
z
The power indicator <ON (G)/STANDBY (R)> will ash slowly in green while the shutter is closed. (
page 58)
z
If the power indicator <ON (G)/STANDBY (R)> is ashing in red, consult your dealer.