Filter
Top Products
Setting
54
- ENGLISH
Settings
Logo PIN code change
J
Logo PIN code can be changed to your desired four-
digit number.
Press ▲▼ to select [Logo PIN code 1 )
change].
Press the <ENTER> button.2 )
Current logo PIN code dialog box appears.
z
Press ▲▼ to enter the current code.3 )
The New Logo PIN code input dialog box
z
appears. Set a new Logo PIN code, a
conrmation box appears, choose [Yes] to set
the new Logo PIN code.
Attention
Be sure to note the new Logo PIN code and keep it on
z
hand. If you lost the number, you could no longer change
the Logo PIN code setting.
HDMI setup
This function is only used for HDMI input source.
Press ▲▼ to select [HDMI setup].1 )
Press ► or the <ENTER> button.2 )
The names for the output setting of Digital R/G/
z
B vary from equipment to equipment.
Image
J
Normal When the output of Digital R/G/B
equipment is set to Standard.
Enhanced When the output of Digital R/G/B
equipment is set to Enhanced.
Sound
J
HDMI
When Digital input source is input,
Sound is set to HDMI.
Computer
When DVI input source is changed
to HDMI input source, Sound is set
to Computer.
Attention
For details, refer to the operating instructions of your
z
Digital R/G/B equipment.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on
the back of the projector is switchable for computer 2
input or monitor output.
Press ▲▼ to select [Terminal] and 1 )
then press the <ENTER> button.
Press ▲▼ to switch the item.2 )
Computer 2 Computer input
Monitor out Monitor out
Note
Terminal function is not available when selecting
z
[Computer 2] to the input source. Change the input
source to the others (HDMI or Computer 1 or Video) so
that the Terminal function will be available.
Power management
For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not operated for a certain period.
Press ▲▼ to select [Power 1 )
management].
Press ► or the <ENTER> button to 2 )
access the submenu.
Mode
J
Press ▲▼ and then press the 1 )
<ENTER> button to select one mode
among the items as below.
Off [Power management] function is off.
Ready When the lamp has been fully cooled
down, the <ON(G)/STANDBY(R)>
indicator changes to green blinking.
In this condition, the projection lamp
will be turned on if the input signal
is reconnected or any button on the
control panel or remote control is
pressed.
Shut
down
When the lamp has been fully cooled
down, the power will be turned off.
Timer
J
Press ▲▼ to select [Timer] and then 1 )
press the <ENTER> button.
Press ▲▼ to set the Timer(1~30min).2 )