Filter
Top Products
Replacement
66
- ENGLISH
Maintenance
Attaching the Lens Cover
When moving this projector or while not using it over an extended period of time, attach the lens cover.
Attach the lens cover according to the following procedures.
Thread the string through the hole on the 1 )
lens cover and then tie a knot in the string
to secure it in place.
To pass the other end of the string into 2 )
the hole on the bottom of the projector
and pull at it.
Attaching the Cable Holder and Ferrite Core
Attach the ferrite core to the USB cable 1 )
as shown in the gure.
Stick the adhesive cable holder 2 )
(supplied) on the bottom of the
projector and store the USB cable in
the holder to prevent the cable from
blocking communication between the
infrared remote receiver and remote
control as show in the gure.
Attention
The USB cable with ferrite core must be used for RF
z
interference suppression.
Infrared remote receiver
Remote control operating range
Interactive camera
Cable holder (supplied)
USB cable
(supplied)
150 mm
Ferrite core