Filter
Top Products
Setting
56
- ENGLISH
Settings
Closed caption
The closed caption is mainly used in the north
America. This function shows the text information
contained in the image signal. Captions may not be
displayed on some devices or software.
Press ▲▼ to select [Closed caption].1 )
Press ► or the <ENTER> button to 2 )
enter the submenu.
Closed caption
J
Press ▲▼ to select [Closed caption] 1 )
and then press the <ENTER> button.
Press ▲▼ to select Off, CC1, CC2, 2 )
CC3 or CC4.
Color
J
Press ▲▼ to select [Color] and then 1 )
press the <ENTER> button.
Press▲▼ to select color or white.2 )
Attention
Closed caption is available only when Video, S-video
z
or Component is selected as the input signal and Auto,
NTST or 480i is selected from the System Menu.
Part of characters may not displayed when high
z
compensation values are set in [Keystone].
Closed captions are not displayed while the menu screen
z
appears.
Lamp power
This function allows you to change brightness of the
screen.
Press ▲▼ to select [Lamp power] and 1 )
then press the <ENTER> button.
Press ▲▼ to select one among the 2 )
modes as below.
You can also press the <LAMP> button to
z
display [Lamp power].
Normal
Brightness according to the input
signal.
Eco
Lower brightness reduces the
lamp power consumption and
extends the lamp life.
Remote control
This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
Press ▲▼ to select [Remote control].1 )
Press ► or the <ENTER> button.2 )
Press ▲▼ to select one among the 3 )
seven codes.
This projector provides 7 different remote
z
control codes: [ALL], [Code 1]~[Code 6].
Attention
When operating the projector under [ALL] code, you can
z
operate several projectors at the same time. If you want
to operate the projector independently, you must switch
to other code.
When different codes are set on the projector and on the
z
remote control, any operation cannot be made. In that
case, switch the code on the remote control to t the
code on the projector.
If the batteries are removed from the remote control for a
z
long period of time, the remote control code will be reset.