Filter
Top Products
Pelco Manual C682M-E (11/01) 13
Evaluate the flow of motion at the surveillance site before programming a schedule. A record-
ing schedule can consist of one of the following modes and/or a combination of all modes:
NORMAL – Continuous recording recommended for surveillance areas with a
lot of movement.
MOTION – Saves disk space; records only when motion is detected.
SENSOR – Saves disk space; records only when an alarm is activated.
Example Schedule 1
Record 4 cameras with motion detection from Monday to Friday,
8:00 AM - 6:00 PM; Saturday 8:00 AM - 2:00 PM; and no recording on Sunday.
1. Select GROUP 01 and set START TIME to 8:00 and END TIME to 18:00.
2. Check MON, TUE, WED, THU, and FRI in the DAY OF WEEK section.
3. Select 01, 02, 03, and 04 in the CAMERA section.
4. Select 01, 02, 03, and 04 in MOTION section.
5. Select GROUP 02 and set the START TIME to 8:00 and END TIME to 14:00.
6. Check SAT in the DAY OF WEEK section.
7. Select 01, 02, 03, and 04 in CAMERA section.
8. Select 01, 02, 03, and 04 in MOTION section.
9. Select GROUP 03 and set END TIME at 8:00.
Example Schedule 2
Record continuously all week. When a signal input is received from sensor 1,
camera 1 starts recording and relay 1 starts operating. A signal input from
sensor 2 starts cameras 2 and 3 recording.
1. Select GROUP 01 and set START TIME to 0:00 and END TIME to 0:00.
2. Check SUN, MON, TUE, WED, THU, FRI, and SAT in the DAY OF WEEK
3. Select 01 in CAMERA and 01 in SENSOR and 01 in RELAY.
4. Select GROUP 02 and set START TIME to 0:00 and END TIME to 0:00.
5. Check SUN, MON, TUE, WED, THU, FRI, and SAT in the DAY OF WEEK.
6. Select 02 and 03 in CAMERA and 02 in SENSOR