Pelco TLR2096 VCR User Manual


 
Pelco Manual C651M (7/99) 13
Figure 1. Typical System Setup
AUDIO
OUT
MIC IN
VIDEO OUTPUT
FROM CAMERA
VIDEO IN
AUDIO IN
MONITOR
VIDEO
OUT
CCTV
CAMERA
VIDEO
IN
MIC
600
VIDEO
OUTIN
IN
OUTMIC
AUDIO
RESET
REMOTE
SET RST
IN
REC GND ALM MODE CLK CALL
OUT
AUDIO IN
ALARM OUTPUT
FROM DEVICE
SET
IN
ALARM DEVICE
4. If you are not using a switcher, refer to Figure 1.
Connect the camera (video output) to the rear of the VCR (video input
BNC). Connect the VCR (video output BNC) to the monitor (video input).
Connect the alarm input to the VCR (SET IN and GND [ground] terminals).
If you are using a 600 microphone, connect it to the VCR (MIC IN jack).
Connect the VCR (audio output connector) to the monitor (audio input).
5. If you are using a switcher, refer to Section 4.3.