Filter
Top Products
22 Connect Peripheral equipment
When you have a digital equipment with a 480p or
1080i output (e.g. a digital Set Top Box or
Progressive DVD player), connect it to the
AV3 or
AV4 IN VIDEO 2 Fh 480p/1080i input.
Connect the equipment with 2 Fh RGB output to
the
RGB connector and to the L and R AUDIO
jacks of AV3.
Connect the equipment with 2Fh YPbPr output to
the
Y, P b and Pr jacks and to the L and R AUDIO
jacks of AV4.
See also the manual of your High Definition
equipment.
Note:This television is designed to accept high definition
signal standards 1080i and 480p as specified by the
Electronic Industries Association standard EIA770.3 as
well as 2Fh-signal standards 576p and 1152i.
Digital devices from different manufacturers have the
possibility of differing output standards which may
cause difficulties for the television to properly display.
Warning: in case you notice scrolling images, wrong
colours or no colour, no picture, or even combinations of
these on your screen, check if the connections are done
in the right way.
The AV3 input can not be used to connect a computer
or any other VGA device.
Headphone
& Insert the plug into the headphone socket L
at the right side of the TV.
é Press ¬ on the remote control to switch off
the internal loudspeakers of the TV.
The headphone impedance must be between 8
and 4000 Ohm.The headphone socket has a 3.5
mm jack.
In the
SOUND menu select Headphone
volume
to adjust the headphone volume.
When the headphone is connected, the
surround mode is always stereo.
Note:
When Dual screen/PIP is activated (see p. 16):
- if the main screen displays a TV channel picture,
you hear the sound from the Dual screen/PIP
picture through your headphone;
- if the main screen displays a picture from a
peripheral equipment, you hear the sound from the
main screen through your headphone.
Note:When using the
S-VIDEO connector do not
connect any device to the video input.
AV 3
IN
AV 4
IN
VIDEO 2Fh
480p/1080i
Y
Pb
Pr
L
R
RGB
AUDIO
Y
Pb
Pr
L
R
AUDIO
AUDIO
VIDEO
S•VIDEO
1 2 3
& Connect your camera or camcorder to sockets
at the right side of your TV.
é Connect the equipment to
VIDEO 2 and
AUDIO L 3 for mono equipment. For stereo
equipment also connect
AUDIO R 3.
S-Video quality with an S-VHS, Hi-8 or Digital
camcorder is obtained by connecting the
S-Video cables with the
S-VIDEO input 1
(instead of VIDEO 2) and AUDIO inputs
3.
Note: If you prefer, you can also connect the
camcorder to one of the TV’s rear
AV IN jacks.
AV3/AV4 Digital High Definition input
Side connections
315 2163.1 (16X24) 22-10-2002 13:15 Pagina 22