Filter
Top Products
9
Install TV Channels
This TV is equipped with Helptext which will time out in 10
sec or upon Remote Control key press.
■ Install TV Channels: This option allows you to Install
TV channels. For the “Install TV Channels” option,
you can do the setting for following options in sub-menu:
• Scan Type: “Cable” to receive TV signals from a cable,
“Air” to receive TV signals from an antenna.
• Install TV Channels: “Auto”, “Manual”
• Confi rmation page to “Start” the TV channels tuning.
• System Searching Status: “Digital Channels Found”,
“Analog Channels Found”
Note
It is important to understand the difference between
physical channel numbers and TV program numbers.
When Auto Install is selected, the TV first scans for
digital channels, starting at a physical (RF) channel 2 and
then increasing in frequency to 3, 4, .... The first digital
program it finds will be installed on TV program 1, the
second on TV program 2 etc. Then the TV scans for
analog channels. For the sake of discussion, let’s assume
that the TV found 36 digital programs. Then the first
analog channel found would be installed as TV program
37, the second as TV program 38 etc. This could be a
big change as most hybrid analog/digital systems have
the analog programs on the lower physical channels
and the digitals on the higher. But this is only the initial
order that the Auto Install creates - the final order of the
channel map that you wish to present to the guest is fully
programmable.
■ Install TV Settings: This option allows you to Install
TV setting. For the “Install TV Settings” option, you
can do the setting for following options in sub-menu:
• Select Your Power On Setting: “Last Status”, “On”,
“Standby”, “Forced On”
• When power to the TV is interrupted, this function
sets the state that the TV will return to when power is
restored.
• If set to Standby, the TV will always resume into
Standby mode when power is restored (default
setting).
• If set to Last Status, the TV will resume to the mode it
was in when power was lost.
• If set to On, the TV will always turn-on into On mode
when power is restored.
• If set to Forced On, the TV will turn-on to On mode,
but it cannot be turned off. (For applications where TV
is always on and you do not want anyone accidentally
turning it off.)
• Default setting is Standby.
• Select Your Keyboard Lock Setting: “ No”, “Yes”, “All”.
• This function enables/disables the Keyboard buttons on
the TV.
• If set to No, all keys are enabled. If set to Yes, all keys
are locked except for the Power key. If set to All, then
all keys are locked including the Power key.
• Default setting is “No”.