Filter
Top Products
11Using your Digital Terrestrial Receiver
ENGLISH
Using your Digital 4
Terrestrial Receiver
Once you have connected your Digital
Terrestrial Receiver, use the remote control to
operate the basic, frequently-used functions,
such as switching on and off, changing channels
and altering the volume.
Watching live TV4.1
Digital Terrestrial Receiver wake-up
To wake up your Digital Terrestrial Receiver
from standby, press one of the following keys
and wait a few seconds:
• on the remote control
P+/P-• on the remote control
Any numerical key of the remote control •
Note
In order to reduce power consumption, switch
your Digital Terrestrial Receiver to standby
mode whenever you are not using it.
For maximum energy saving we recommend
you to switch off the Digital Terrestrial Receiver
by unplugging the AC adaptor of the Digital
Terrestrial Receiver if you are not using it for a
long time.
Channel selection
To change channels, use P+/P- or the numerical
keys of the remote control.
Press P<P / BACK to return to the previously
tuned channel.
As soon as the scan is completed, a window
is displayed. Press OK to close it.
Press OK again.
Now all the available channels are scanned and
registered on your Digital Terrestrial Receiver.
Note
If the signal quality is poor, a message prompting
you to check your antenna/cable is displayed.
Check your cable connections and scan for
channels again.
If you do not receive channels that should be
available, check also the Coverage of your area:
See http://www.freeview.co.uk