Filter
Top Products
12 Hookups (cont’d)
Connecting to a TV Only
TV has Component Video In Jacks
Back of TV
(example only)
Pr/Cr
Pb/Cb
Y
RIGHT AUDIO IN
LEFT AUDIO IN
LEFT AUDIO IN
RIGHT AUDIO IN
Cr/R-Y
Y
Cb/B-Y
S-VIDEO
(Y/C)
ANTENNA
TV
S-VIDEO
(Y/C)
VIDEO
(CVBS)
VIDEO
(CVBS)
COMPONENT
VIDEO
AUDIO
COMPONENT
VIDEO
AUDIO
Y
P
B
P
R
Y
P
B
P
R
IN - EXT 2 IN - EXT 1
OUT 2 OUT 1
480p/480
i
COAX OUT
G-LINK
DIGITAL AUDIO OUT
OPTICAL OUT
MAINS
AUDIO
L
R
AUDIO
L
R
Antenna
or Cable TV
Signal
DIGITAL AUDIO OUT
1
Connect your Antenna or Cable TV signal to the ANTENNA jack on
the rear of the Recorder.
2
Connect the Recorder’s OUT 1 COMPONENT VIDEO Y PB PR
jacks to the COMPONENT VIDEO IN jacks on the TV. Use the sup-
plied three-strand component video cable, which has red, blue, and green
markings. Match the cable colors to the jack colors.
3
Connect the Recorder’s OUT 1 AUDIO L/R (left/right) jacks to the
left/right AUDIO IN jacks on the TV. Use the supplied two-strand audio
cable, which has red and white markings. Match the cable colors to the jack
colors.
4
Connect the supplied power cord to the MAINS ~ (AC Power) jack
on the rear of the Recorder.
Connect the power cords of the Recorder and the TV to a power
outlet.
5
Press STANDBY-ON
yy
on the front of the Recorder to turn it on.
“IS TV ON? CH03” will appear on the Recorder’s display panel the first time
you turn on the Recorder.
6
Turn on the TV. Set it to the Component Video In channel, not chan-
nel 3 or 4. (See your TV manual for details. Or,go to your lowest TV channel
and change channels down until you see the DVD background picture or
Initial Setup screens.) Initial Setup will appear the first time you turn on the
Recorder. Go to pages 18-20 to complete Initial Setup.
•
If your TV has Progressive Scan
(Pro Scan), connect the
Recorder’s OUT 1 COMPO-
NENT VIDEO Y P
B PR jacks to
the TV’s Progressive Scan In jacks
instead. Pro Scan doubles the
number of visible picture lines
per field, providing a jitter-free,
sharp, quiet picture. See your TV
manual for details. If you use Pro
Scan, set the Recorder’s Video
Output to Progressive Scan. See
page 58.
• On the TV, the Component Video
In jacks may be labeled YUV or
Pr/Cr Pb/Cb Y and may be green,
blue, and red.
• To watch TV with the Recorder
off, connect the RF coaxial cable
to the Recorder’s TV jack and to
the RF IN or ANTENNA IN jack
(75 ohm) on your TV. This lets
you watch channels at the TV
when the Recorder is off and will
improve TV reception. See page
10 for this hookup.
Helpful Hints