Filter
Top Products
64
Problem solving for programmed
recordings
PROBLEM SOLUTION
DVD Recorder does not
respond
bWhile a programmed recording is being made, you cannot operate your DVD Recorder
manually. If you want to cancel the programmed recording, press STANDBY m .
'Switch off, timer recording'
flashes on the TV screen.
bThe DVD Recorder was switched on a few minutes before the start of a programmed
recording.
Turn off the DVD Recorder by pressing STANDBY m . A programmed recording (timer)
will only function if the DVD Recorder is switched off (button STANDBY m ).
Fehlermeldung: 'Insert
recordable disc'
bEither no disc was inserted or a disc was inserted that cannot be used for recordings. Insert a
disc that can be recorded upon. Turn off the DVD Recorder by pressing STANDBY m .
The error message 'Disc
locked' appears briefly on
the screen.
bA protected disc was inserted. Undo the erase protection (chapter 'Manual recording', section
'Preventing accidental erasing of discs '), or insert a different disc.
Error message: 'Memory
full'
bIf this error message appears after pressing TIMER , then all TIMER blocks are already
programmed. No more recordings can be programmed. Press the C button. Select the
programmed recording (TIMER block) you want to check or clear using CH+ A or CH- B .
The 'Data error' message
appears on the screen.
bThe data for the recording could not be transferred. Please check date, start time, and end
time of the programmed recording.
The message 'Collision'
appears on the screen.
bThe timer recording overlaps with another timer recording.
bIf you ignore this warning, the programmed recording with the early start time will start first.
The second recording will then lack the beginning.
bChange the information for one of the two recordings.
bDelete one of the two recordings.
Programming a recording (TIMER)