Filter
Top Products
77
PROBLEM SOLUTION
No playback on DVD
recorder:
bThere is no recording on the disc: Change disc.
bYou inserted the wrong disc type: Your Recorder can play the following disc types: DVD
Video, (Super)Video-CD, DVD+R(W), Audio-CD, , MP3-CDs
bYou inserted the disc the wrong way: Insert the disc with the label facing up.
bThe disc is dirty. Clean the disc.
bWrong region code: The region code of the DVD and the DVD Recorder must match.
bThe child lock is on. Read chapter 'Access Control (Child Lock)'
bYou have selected or set the wrong channel number on the TV for the DVD recorder: Select
the correct channel number on the TV (channel 3 or 4).
bThe cable connecting the TV and the DVD Recorder may be loose. Check the cable.
I cannot playback (Super)
Video CDs
bIt is possible that this (Super) Video CD contains a menu and the 'PBC' is switched off. You
can see this in status field 'PBC OFF'. To activate this function, proceed as follows:
1 Press SYSTEM-MENU while the (Super) Video-CD is inserted.
2 Select '
A
' using D or C .
3 Select line 'Features' using CH- B or CH+ A and confirm with C .
4 Select 'On' in line 'PBC' using CH- B or CH+ A .
5 Confirm with OK and end with SYSTEM-MENU .
Poor playback on DVD
Recorder (distorted
picture/distorted sound)
bYour TV is not properly adjusted.
bThe disc is dirty: Clean the disc.
bSometimes the picture may be temporarily distorted. This is not a defect of your DVD
recorder.
No recording possible. bThe TV channel you want to record is not stored or you selected the wrong program
number: Check TV channels stored.
bDisc is write-protected (cannot be recorded on): Remove write-protection or change the disc.
For more information, please see 'Preventing accidental erasing of discs' on the 'Manual
Recording'.
bA finalized DVD+R has been inserted. Change disc.
Programmed recording
does not work:
bYou have set the wrong time or date: Check time/date.
bYou have not set the TIMER properly: Check the programmed recordings (TIMER block).
bA locked disc was inserted: Remove disc lock.
bA finalized DVD+R has been inserted. Change disc.
The wrong TV channel was
decoded (recorded) after
you programmed a
recording using the VCR
Plus+ system.
1 Enter the PlusCode programming number of the desired TV channel.
2 Confirm with OK .
3 Check the channel number in the 'Ch.' input field
4 If this does not correspond to the desired TV channel, select this entry field and
change the channel number.
5 Confirm with OK .
There is picture or sound
interference with the TV
reception.
bDuring playback via the internal TV tuner ( MONITOR button), switch to recording mode
'M1' by pressing REC MODE . This will give you the best possible picture quality.
Before making the recording, select the recording mode as described in chapter 'Manual
recording', section 'Selecting the recording mode (quality)'.
bChange the modulator channel. During standby hold on the remote the button 3 pressed to
switch to channel 3. With button 4 you switch to channel 4.
bHave your antenna or cable TV signal checked.
ENGLISH
Before you call technical support