Filter
Top Products
English
30 DVD to Videotape Duplication
Follow the steps below to copy a DVD to a videotape. This will
be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough to record
the DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so VCR light appears on the front of the DVD/VCR.
●
Turn on the TV and set it to channel 3, 4 or its Video Input.
1
Point the remote control at the DVD/VCR. Press Number
buttons 0, 0, 3. “DISC” will appear on the TV screen.
2
Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about tape
speed are on page 60.
3
Press RECORD
I
to start recording. “REC” will appear
on the display panel.
4
Press DVD. Press
PLAY B
to play the disc.
5
To pause the recording, press VCR, then press
PAUSE
k
once. “REC” will flash. To resume recording,
press RECORD
I
or press PAUSE
k
again. “REC” will
reappear.
6
To stop recording, press VCR, then press STOP
C
.
DISC
3,5
6
1
5
2
4
5,6
STANDBY-ON
PLAY
DVDVCR VCR/TV
OK
MENU MENU
DISC/VCR
RETURN TITLE
A-B
CLEAR/RESET SLOW
SUBTITLE ZOOM
ANGLE
REPEAT REPEAT
AUDIO
SEARCH MODE
DISPLAY
SKIP / CH
SYSTEM
PAUSESTOP
MARKER RECORDTIMER SET
SPEED
1 2 3
7
6
5
4
8
9
0
+10
•A timer recording is not
possible during DVD to
videotape duplication.
•You cannot copy a DVD to a
videotape if you are using
Progressive Scan. Details are on
page 14.
Helpful Hints
H982NUD_EN1 3/2/06 6:56 PM Page 30