Philips HTS3101/93 DVD Player User Manual


 
44
English
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs,  rst check the points listed below before taking the system for repair. If
you are unable to solve a problem by following these instructions, consult your dealer or
Philips for help.
No power.
No picture.
Completely distorted picture
or black/white picture.
No sound or distorted sound.
There is no sound from the
centre and rear speakers.
The remote control does not
function properly.
Check if the AC power cord is properly connected.
– Press the 2(STANDBY ON) on the front of the
DVD system to turn on the power.
Refer to your TV’s manual for correct Video In
channel selection. Change the TV channel until you
see the DVD screen.
Press the DISC button to select disc mode.
If this happens when you are turning on the progressive
scan feature, wait for 15 seconds for the auto recovery.
If this happens when you are changing the setting of the
‘TV TYPE’, wait for 15 seconds for the auto recovery.
Check the video connection.
Sometimes a small amount of picture distortion may
appear. This is not a malfunction.
– Clean the disc.
Adjust the volume.
Check the speaker connections and settings.
Make sure that the audio cables are connected and
press the SOURCE button to select the correct input
source (for example, TV or AUX/DI) to choose the
device that you want to hear through the DVD system.
Make sure that the centre and rear speakers are
connected correctly.
Press the SURR. button to select a correct surround
sound setting.
Make sure that the source you are playing is recorded or
broadcast in surround sound (DTS, Dolby Digital, etc.).
Select the source you want to play (for example,
DISC or TUNER) before pressing the function button
(X, ./ >).
Reduce the distance between the remote control and
the system.
Replace the batteries with new ones.
Point the remote control directly toward the IR sensor.
Check that the batteries are loaded correctly.
Problem (General) Solution