Filter
Top Products
21
Optional setup
In the optional setup procedure you can customize your Media Center.The setup wizard enables you to:
– configure tuners,TV signal, and TV program guide information;
– select and adjust Media Center display settings;
– setup of speakers;
– control of your set-top box.
Configure tuners,TV signal and Guide
This option enables you to configure your connections for TV and radio signals.
1 Confirm your region.
2 Select the TV signal.
3 Make your selection for a set-top box:
• Cable. Continue with ´Analogue setup´.
• Antenna:
- Analogue. Continue with ´Analogue setup´.
- Digital. Continue with ´Digital setup´.
Analogue setup
1 Select the type of TV signal (Europe - PAL/SECAM).
2 Make your selection for a set-top box:
a If you have a set-top box:
• Make sure that your set-top box and IR-receiver cable are connected properly (see ´Installation of your Philips Media
Center – Connecting video equipment (e.g. a set-top box)´).
• Select a TV signal
b If you do not have a set-top box:
• Follow the on-screen instructions.
3 Setup Electronic Television Program Guide.
• Read the Guide Terms of Service and accept.
• Enter your postal code.
• Select your TV signal provider.
> Your Media Center uses the internet connection to download all TV station information from your TV signal provider.
Every available station is stored as a separate preset number.
Digital setup
1 Select the type of TV signal: ´Digital terrestrial (DVB-T)´.
2 Make your selection for a set-top box:
Select ´No´.
3 Read the Guide Privacy and accept.
4 Setup Electronic Television Program Guide.
• Read the Guide Terms of Service and accept.
• Enter your postal code.
• Downlaod the provider information
• Select your TV signal provider. Select ´Digital terrestrial – all channels´.
• Download the TV Program Guide Information.
Optimize how the Media Center looks on your display
This option enables you to adjust display settings.
1 Select your display type.
2 Select the connection type of your display.
Note: If you are using the SCART output (21) of the Media Center, select Component (YpbPr).
3 Adjust display settings to your personal preferences in Display Calibration.
Note: If you select a wrong display setting the screen may turn black. Please wait for about 15 seconds, then the on-screen infor-
mation will be be visible again.