Filter
Top Products
7
Tips:
• When you have locked TV channels while initiating autoprogram, a message appears asking to enter your PIN code in order to complete autoprogramming.
• When interrupted, the updated channel information is retained as well as the old channel information that were not updated.
• Background autoprogramming occurs only when the TV is turned on.
• Channel information of an ATSC channel is updated only for the ATSC channel currently tuned.
• If an NTSC channel is tuned, then in Background Autoprogramming the TV will scan all the possible ATSC frequencies and update information.
• Weak channel installation : This allows you to manually tune weak ATSC channels in order to adjust the antenna and thus optimize signal quality for that
channel. (See Installation menu, Weak channel installation, p. 8.)
• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
& Select Autoprogram in the Installation menu.
é Use the cursor right button to enter the Autoprogram menu.
“ Press the OK.
‘ Select Cable or Antenna in the Installation mode.
When
Antenna is selected, the TV will detect antenna signals and will
search for antenna TV (NTSC and ATSC) channels available in your local
area.
When
Cable is selected, the TV will detect cable company supplied signals
and will search for cable TV (NTSC, ATSC, QAM modulated) channels
available in your area.
Make sure you complete registration with your cable TV provider and
connection of equipment.
( Press the green button “Next” on the remote control.
Note: All channels must be unlocked in order to autoprogram. If requested, enter
your PIN code to unlock all channels. See section on Menu preferences under
Settings, TV menu.
§ Press the green button “Start” to start autoprogramming.
The menu screen disappears and the progress of autoprogramming is
displayed. The progress bar indicates the number of analog and digital TV
channels found.
When Autoprogramming is complete, a message appears confirming the
completion. Press the red button "Finish" and the screen returns to the
Installation menu.
& Press the MENU button on the remote control.
é Use the cursor down button to select Installation in the Settings menu.
“ Use the cursor right button to enter the Installation menu.
‘ Select Language and enter the list of available languages with the cursor
right button.
( Select your language with the cursor up/down buttons and press OK to
confirm your selection.
§ Proceed with the Installation menu.
Store the TV channels
Select the menu language
Installation
Installation 4 Language 3
English
Francais
Settings
Software upgrade
Espanol
Autoprogram
Weak channel installation
Language
Press the cursor right to select your menu language.
Installation mode
Please select your
installation mode.
Television installation
Cable
Antenna
Previous Next
Television installation
You can now start automatic installation. This
procedure can take more than half an hour.
Previous Start