Filter
Top Products
Watching TV 17
The unit selects available TV channels automatically when you
connect an Antenna or Cable TV signal to it. To reset TV
channels, see page 20.
If you are using a Cable Box or Satellite Receiver, you do not
need to set channels at the TV/DVD.
1
Press STANDBY-ONy to turn on the TV/DVD.
2
To watch TV, press CH. ▲/▼ to select memorized
channels. Memorized channels are those that appear
when you flip through channels. If a channel is skipped,
you still can use the Number buttons to select it. This
is a non-memorized channel; it may have weak
reception in your area.
To update your memorized and non-memorized
channels, see page 19.
Remember, if you are using a Cable Box/Satellite
Receiver, set the TV/DVD to channel 3, 4 or AUX.
Change channels at the Cable Box/Satellite Receiver.
3
Press VOL.
X
/
Y
to adjust the volume.
VOLUME 20
0
123
456
7
8
9
+10
+100
CLEAR
PREV NEXT
PLAY
STOP
RETURN
MODE
SELECT
PICTURE
/SLEEP
DISPLAY
CH. VOL.
MUTE
DISC SET-UP
MENU
SLOW PAUSE
TITLE
STANDBY-ON
OPEN/CLOSE
ENTER
3
1
2
• If the TV screen shows snow
noise and there is no operation
for more than 10 seconds,
“HELPFUL HINTS” appears.
Helpful Hint
- HELPFUL HINTS -
1.PLEASE CHECK TO SEE IF
THE ANTENNA/CABLE/
SATELLITE IS
PROPERLY CONNECTED.
2.DID YOU PERFORM
“AUTO CH PROGRAMMING”?
3.PLEASE REFER TO FRONT
PAGE OF THE OWNER’S
MANUAL OR REAR PANEL
FOR SUPPORT LINE
INFORMATION.
T9201UB_EN 3/7/06 11:06 AM Page 17