Filter
Top Products
24 Setting the Clock (cont’d)
4
If you already know your PBS channel number,
skip ahead to step 8. If you do not know the
channel number of your PBS station, press ▼ to
select AUTO CLOCK CH SEARCH.Then press
ENTER.
● The TV/DVD/VCR will search for a channel that
carries a time signal. Channels that carry the time
will appear at the top of the screen. Use one of
these channels when you enter your AUTO
CLOCK CH at step 9.
This may take several minutes.An ‘’_ _” appears in
the lower left corner of the screen when the search
is complete.
5
Press SETUP to remove the AUTO CLOCK
CH SEARCH screen.
6
Press SETUP to access the menu again.
7
Press ▲ or ▼ to select SETTING CLOCK.
Then, press ENTER.
8
Press ▼ to select AUTO CLOCK CH,
then press ENTER.
9
Press { or B until the channel number of your
PBS station appears. Use the channel number
you found at step 4.
– SETTING CLOCK –
AUTO CLOCK
AUTO CLOCK CH SEARCH
AUTO CLOCK CH
MANUAL CLOCK SET
D.S.T.
B
[ON]
[08]
[OFF]
– SETTING CLOCK –
AUTO CLOCK
AUTO CLOCK CH SEARCH
AUTO CLOCK CH
MANUAL CLOCK SET
D.S.T.
B
[ON]
[02]
[OFF]
10
Press SETUP to remove the menu.
11
Press STANDBY-ON to turn off the
TV/VCR/DVD and let the PBS channel update
the clock.
• During the Auto Clock
Channel Search, the picture
may be distorted.This is
normal.
• If there are no PBS stations
available, set AUTO CLOCK to
OFF. Set the clock manually.
• If the TV/VCR/DVD is
connected to a Cable Box or
Satellite Receiver, select the
local PBS station on the Cable
Box/Satellite Receiver. Set the
TV/VCR/DVD to the output
channel of the Cable
Box/Satellite Receiver (03, 04
or AUX).
Helpful Hints
– AUTO CLOCK CH SEARCH –
08 10 13
– –
PLAY
STOP
ENTER
RECORD
DISC
MENU
RETURNTITLESETUP
A
-
B
REPEATSEARCH MODE
CLEAR
MODE
ANGLESUBTITLEAUDIO
DISPLAY
SPEED C.RESET
STANDBY-ON
PICTURE SELECTSLEEP
CH.
VOL.
MUTE
ZOOM
123
456
789
0 +10
+100
REPEAT
11
4,7-9
5-6,10
Instructions continued from the previous page.
T2132_1102_0102_EN1_0303 3/3/05 10:18 AM Page 24