Filter
Top Products
VCR/TVPOWER EJECT
1 2 3
4 5 6
7 8 9
0 +100
CHANNEL
SPEED
RENTAL
SELECTOR
AUTO
REPEAT
CLOCK/
COUNTER
EXIT COUNTERDISPLAY
MENU
RESET MEMORY
REWIND / PLAY F.FWD
RECORD PAUSE/STILL
/ STOP
Repeat Play 33
Follow the steps below to program the VCR to play a tape over
and over. Make sure:
● The VCR is on and is in VCR position. The VCR/TV light will
appear on the front panel. If it does not, press the VCR/TV but-
ton once.
● There is a tape in the VCR.
1
Press the MENU button repeatedly until the VCR SET
UP menu appears.
2
Press the PLAY button or the STOP button repeatedly to
select AUTO REPEAT.
3
Press the F.FWD button so that [ON] appears next to
AUTO REPEAT on-screen. Tape playback will begin immedi-
ately. AUTO REPEAT B will appear on-screen briefly.
(If you are fast forwarding or rewinding the tape, you must first
press the COUNTER RESET/EXIT button to exit, then press the
PLAY button to begin tape playback.)
The VCR will play the tape to the end, rewind it, then play it
again. (TV programming will appear on-screen while the tape is
rewinding.)
1
3
2
VCR SET UP
→ AUTO REPEAT
RENTAL
AUTO RETURN
VCR SET UP
→ AUTO REPEAT
RENTAL
AUTO RETURN
• You also may set AUTO REPEAT to
ON or OFF by pressing the AUTO
REPEAT button on the remote con-
trol. However, there may be no
indication of your selection on-
screen when you press the AUTO
REPEAT button during tape play-
back. (You may press the DISPLAY
button to confirm that AUTO
REPEAT is active.)
• To cancel AUTO REPEAT, follow
steps 1 - 2 above. At step 3, press
the F.FWD button so that [ON] no
longer appears beside AUTO
REPEAT. Press the COUNTER
RESET/EXIT button to exit.
• The COUNTER MEMORY button
does not function if AUTO REPEAT
is set to [ON].
• The real-time counter memory is
cancelled if AUTO REPEAT is set to
[ON].
Helpful Hints
SVZ122(H1680).QX33 4/6/99 9:42 PM Page 33