Filter
Top Products
Timer Recording (cont’d) 35
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10 CABLE/TV
TIME ON – – : – – – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10 CABLE/TV
TIME ON 09:30 PM
TIMEOFF – – : – – – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
5
Use the Number buttons to enter the channel you want
to record.
• If you are using a standard antenna or cable to VCR to TV
hookup (as shown on pages six - seven), enter the channel of
the TV program you want to record.
• If you are recording from line input, press 0, 0. A/V REAR will
appear on-screen.
• If you are using a Cable Box or a DSS Receiver, enter the out-
put channel of your Cable Box or DSS Receiver (usually channel
03 or 04). See pages eight, nine, and 58 for more information.
6
Press two Number buttons for the hour you want the
recording to begin. Press two Number buttons for the
minute(s) you want the recording to begin. Press 1 for
AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.
7
Follow the instructions in step 6 to set the recording’s
stop time.
Instructions continue on page 36.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
4
Use the Number buttons (1 - 8) to select a slot in which
to store the timer recording. Flashing numbers indicate an
open slot (one in which a timer recording has not yet been
stored).
NOTE: If you select a number that has already been used to store a
timer recording, PREVIOUSLY SET PROGRAM will appear on-screen for
a few seconds. Then information about the program in that slot will be
displayed on-screen. If this happens, press the EXIT/STATUS button.
Then start again at step 1.
...
...
POWER
CBL/DSS
VCR TV
EJECT MUTE
MENU
EXIT/STATUS
CLEAR
VCR PLUS+
/ENTER
LIGHT
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0
GO-TO
MEMORY
INDEX
VAR. SLOW
REMOTE LOCATOR
SKIP
VCR/TVSPEED
SEARCH
SLOW
TRACKING
STOP
REW FF
PLAY
VOL CHANNEL
/OTR
REC
4-7
• If the preset time for a timer record-
ing comes up during a One Touch
Recording, the OTR has priority.
• If you leave the VCR on past the
scheduled start time of a timer
recording, you will not be prompted
by the VCR again to turn off the
VCR. When you turn off the VCR, the
timer recording will not take place.
• If the end of the tape is reached dur-
ing a Timer Recording, recording will
stop. The VCR will eject the tape,
then turn itself off.
Helpful Hints