Filter
Top Products
Setting the Controller to Operate a DSS Receiver 45
TO SELECT PUSH NO. SHOWN
1 PROGRAM
2 VCR SET UP
3 TUNER SET UP
4 INPUT SELECT
5 SET CLOCK
6 SET REMOTE LOCATOR
TO END PUSH EXIT
TO SELECT PUSH NO. SHOWN
1 SET REPEAT PLAY (OFF)
2 ON SCREEN MODE
3 LANGUAGE
4 SET VCR PLUS+ CH
5 SET CABLE BOX
6 SET DSS RECEIVER
7 AUDIO OUT
8 VIDEO STABILIZER (OFF)
TO END PUSH EXIT
DSS RECEIVER CONTROLLER
OFF
TO SELECT PRESS NUMBER
1 ON
2 OFF
TO CONTINUE PUSH MENU
TO END PUSH EXIT
• If you use a DSS Receiver, you must set the clock manually.
Details are on page 14.
• Complete the steps on page 27 before proceeding. This will
allow you to use the VCR remote control to operate the DSS
Receiver, and you will learn your DSS Receiver code.
1
Turn on the DSS Receiver; select a channel other than
205 at the DSS Receiver.
2
Press the VCR button, then press the MENU button.
3
Press the Number 2 button to select VCR SET UP.
4
Press the Number 6 button to select SET DSS RECEIVER.
5
Press the Number 1 button to set the DSS RECEIVER
CONTROLLER to ON.
...
...
POWER
CBL/DSS
VCR TV
EJECT MUTE
MENU
EXIT/STATUS
CLEAR
VCR PLUS+
/ENTER
LIGHT
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0
GO-TO
MEMORY
INDEX
VAR. SLOW
REMOTE LOCATOR
SKIP
VCR/TVSPEED
SEARCH
SLOW
TRACKING
STOP
REW FF
PLAY
VOL CHANNEL
/OTR
REC
• The Controller can change channels
at the DSS Receiver only during a
timer recording.
• If the VCR’s remote control does not
operate your DSS Receiver, the
Controller will not change channels at
the DSS Receiver during a timer
recording. In this case, you must
select the channel to be recorded at
the DSS Receiver before a timer
recording begins. Leave the DSS
Receiver on for the timer recording.
Details are on page eight.
Helpful Hints
Instructions continue on page 46.
DSS RECEIVER CONTROLLER
ON
TO SELECT PRESS NUMBER
1 ON
2 OFF
TO CONTINUE PUSH MENU
TO END PUSH EXIT
2
1
Turn on the DSS Receiver.
Select a channel other than
205.
3
4
5