Filter
Top Products
Problem solving
If a fault occurs, first check the points listed below. If you are unable to
remedy a problem by following these hints, contact the helpline
(see ‘Need help?’) or consult your dealer.
Never try to open the set yourself as this will void the guarantee.
First, check all cables to ensure that they are connected correctly.
Problem Solution
No picture on TV2 • Ensure that both units are switched on
(both green power lights (1 and 9) are lit).
• Select the EXT or AV channel on TV2.
• Activate the video source you would like to watch
(set-top box: power on;VCR/DVD: playback).
• Select the same channel on the receiver and transmitter units,
using CHANNEL switches 6 and 14.
• If a VCR is used as the video source, ensure that the correct
SCART connector of the VCR is being used.
(Ext. 1 or Ext. 2. Check VCR User Manual).
Bad picture/sound • Move the receiver unit around on the surface it is positioned on,
quality on TV2 centimetre by centimetre until you get good picture and sound quality.
• Carry out the same procedure for the transmitter unit.
• Change both units to another frequency channel, using CHANNEL
switches 6 and 14.
Make sure that both units use the same frequency channel.
• Reduce the distance between the transmitter and receiver units
(less than 30 metres).
The cable • Disable the auto standby mode of the VCR. (Check VCR’s User Manual).
programme you
are watching
disappears after
several minutes
Wrong picture on • Select the EXT or AV channel on TV2
TV2 • Activate the video source you would like to watch
(set-top box: power on;VCR/DVD: playback).
• It is possible that a signal from another Wireless TV Link is being picked
up. Switch to another channel on both units,
using CHANNEL switches 6 and 14 to receive your own signal.
Make sure that the same channel is selected on both units!
ENGLISH 11
XP SBC VL1100 07-02-2003 12:48 Pagina 11