Filter
Top Products
09
68
En
No picture is displayed or the
picture is not displayed
properly.
Are you using an extremely
long cable?
Using an extremely long cable may result in noise. Use a relatively short
cable.
Picture freezes and the front
panel and remote control
buttons stop working.
• Press STOP to stop playback, then restart playback.
• If the playback cannot be stopped, press STANDBY/ON on the
player’s front panel to turn off the power, then turn the power back on.
• If the power cannot be turned off, press and hold STANDBY/ON
on the player’s front panel for over 5 seconds. The power will turn off.
Motion is unnatural or
picture is not clear.
Change the Pure Cinema setting (page 39).
No picture is displayed or
picture is not output in high
definition when playing BDs.
With some discs, it may not be possible to output the video signals from
the
VIDEO
output terminal or the
COMPONENT VIDEO
output
terminals. In this case, connect using an HDMI cable (page 18).
• Picture is disturbed during
playback.
• Picture is dark.
• This player supports Macrovision analog copy protection technology.
With some TVs (such as with built-in video deck), the picture will not be
displayed properly when the copy protected DVD title is played. This is
not a malfunction.
• If the player and TV are connected via a DVD recorder/video deck,
etc., the picture will not be displayed properly due to analog copy
protection. Connect the player and TV directly.
• Picture is stretched.
• Picture is cropped.
• Aspect ratio cannot be
switched.
Is the TV’s aspect ratio
properly set?
Read the TV’s operating instructions and set the TV’s aspect ratio
properly.
Is TV Aspect Ratio properly
set?
Set TV Aspect Ratio properly (page 42).
Is 4:3 Video Out properly
set?
Set 4:3 Video Out properly (page 42).
Is DVD 16:9 Video Out
properly set?
Set DVD 16:9 Video Out properly (page 42).
When video signals with a resolution of 1080/60i, 1080/60p, 720/60p,
1080/24p, 1080/50i, 1080/50p or 720/50p are being output from the
HDMI OUT
terminal or the
COMPONENT VIDEO
output terminals,
they may be output with an aspect ratio of 16:9 even if
TV Aspect Ratio
is set to
4:3 (Standard)
(page 42).
Picture is interrupted. The picture may be interrupted when the resolution of the recorded
video signal switches. Press OUTPUT RESOLUTION to select a setting
other than Auto or Source Direct (page 27).
The subtitles cannot be
switched.
The subtitles cannot be switched for discs recorded on a DVD or BD
recorder.
Sound and picture are not
synchronized.
Is Output Terminal properly
set?
Set Output Terminal properly (pages 23 and 51).
Is Lip Sync properly set? Adjust the amount of audio delay with the Lip Sync setting (page 41).
• No sound is output.
• Sound is not output
properly.
Is the disc played back in
slow motion?
Is the disc played back in fast
forward or fast reverse?
No sound is output during slow motion play and forward and reverse
scanning.
Are the audio cables properly
connected?
• Connect the cable properly according to the connected devices
(page 18).
• Insert the cable firmly and all the way in.
Is the audio cable damaged? If the cable is damaged, replace it with a new one.
Are the connected
components (AV receiver or
amplifier, etc.) properly set?
Read the operating instructions of the connected components and
check the volume, input, speaker settings, etc.
Problem Check Remedy
V6000_CUXJ_EN.book 68 ページ ２００９年６月５日 金曜日 午前１１時５７分