Filter
Top Products
IBM DOS / WINDOWS Driver Installation Chapter 3
Owner’s Manual / Software Driver Installation Guide 3-13
Notice – Changes Not Saved
This dialog box will appear whenever you select Custom Install, change some of
the parameter settings, and then decide not to save them. It is basically warning
you that the changes have not been saved and the default settings have been
retained. When you press [ESC] you will be returned to the Main Menu, with
QUICK INSTALL highlighted.
Installing More Than One Pioneer CD-ROM Drive
Installing Two Pioneer CD-ROM Changers on one SCSI Chain
Two Pioneer Changers can be installed on one SCSI chain by using the Pioneer
device drivers for IBM-PCs and compatibles that ship with the unit. Use a
Centronic 50 Pin SCSI cable to connect the two drives. Make sure the drive in the
middle of the chain is not terminated and the last drive is terminated. Assign each
drive it’s own specific SCSI ID number. Then select CUSTOM INSTALL and
indicate the SCSI ID numbers of each drive and the number of discs to be
accessed by each drive.
You can also enter the SCSI ID numbers of the two units into the Pioneer Device
Driver line in the CONFIG.SYS with the /S: switch as indicated in the example
below. Also, the /N: switch must be placed into this line to indicate the number
of discs (1-6) to access in each unit.
DEVICE = C:\DEV\DRD600.SYS /D:MSCD000 /N:6,6 /S:0,1 /C:CDP
Figure 16 - DOS/WINDOWS - NOTICE Changes Not Saved
P
ioneer CD-ROM Installer Ver 2.0