Filter
Top Products
MACINTOSH Driver Installation Chapter 4
Owner’s Manual / Software Driver Installation Guide 4-5
Operations Check
Other Installation Options
If you ar installing more than one SCSI Device, make sure the SCSI devices on
the chain each have individual SCSI ID address numbers between 1 and 6 when
the Pioneer Changer is connected to a Macintosh computer. Only the last device
on the SCSI chain is terminated. All other devices should not be terminated.
CHECK ICONS ON BOOT UP:
If CLD Access has been installed properly and a Pioneer CD-ROM Changer is attached
via SCSI cable to the Macintosh and powered ON, the following icon will be seen at the
bottom of the screen at start-up. Look for it, to make sure it has been installed properly.
CHECK THAT THESE FILES ARE LOADED PROPERLY
Under System 7.0 and above, CLD Access and Apple CD-ROM files should be in the
Control Panel Folder. ISO 9660, High Sierra, Foreign File Access and Audio CD
Access should be in the Extension Folder.
If you are running System 6.0.7 or below, all of these files should be in the System
Folder: CLD Access 1.2, ISO 9660, High Sierra, Foreign File Access, Audio CD Access.
If the Pioneer Macintosh Drivers have been installed, but the CD-ROM Changer is not
connected to the Macintosh and Powered ON, the following icon will appear on boot-up.
NOTE: If you are using the Apple CD 150 or CD SC Plus, or CD SC with the
Pioneer CD-ROM Changer and running System 6.0.7 or below, DO NOT install
the Apple CD-ROM device driver. If an Apple CD-ROM driver is installed,
remove it. CLD Access 1.2 supports the Apple Drives listed above. If you are using the
Pioneer CD-ROM Changer with the Apple CD-300 or CD-300i (for Power PC) or newer
Apple CD-ROM drives and running System 6.0.7, use CLD Access 3.0 and Apple CD-
ROM Driver v 5.0.1. Drag them from the CD-ROM Folder into the 6.0.7 System Folder.
CLD-Access 1.2 does not support newer Apple CD-ROM drives. If you install CLD-
Access 3.0 under System 6.0.7 or below, enable MultiFinder, then restart. CLD-Access
3.0 will not change discs in regular Finder mode. With System 7.0, install CLD-Access 3.0
and the Apple CD-ROM 5.0.1 if using a Pioneer Changer with an Apple CD-ROM drive.
✓