Filter
Top Products
42
09 Advanced Setup Menu
DISC: All content on the disc plays back
again (repeats).
• SERIAL PORT
Set the RS-232C interface to use with a 15-pin
connector or a 9-pin connector. Only a single
type of connector may be used at a time.
Use / (cursor left/right) buttons to
alternate between 15 Pin and 9 pin (Default
setting is 15 Pin).
15 Pin: When connecting to a PC
using a Pioneer or other
brand 15-pin to 9-pin cable.
9 Pin: When connecting to a PC
using a commercial 9-pin
cross-cable.
• BAUD RATE
Set the Baud rate for the RS-232C
interface.
Use / (cursor left/right) buttons to
alternate between 19200 bps and 9600 bps
(Default setting is 19200 bps).
• EXTEND TERMINAL
Use the Extend Terminal to select a switch-
key setting.
Use / (cursor left/right) buttons to
alternate between Standard and User
(Default setting is Standard).
Standard: The unit responds according to
established jama commands.
User: The user selects how the external
option key responds. Press
ENTER to activate this option
(see page 46).
.
• SYNC OUT (During SQ)
Use SYNC OUT to determine if a video signal
is sent when the player is not playing video.
Use / (cursor left/right) buttons to
alternate between ON and OFF (Default
setting is OFF).
OFF: Video is output constantly; the
sync signal is ON.
ON: Video is not output except
during playback and when
displaying menu screens
(sync signal is OFF).
Power On Start
Sets playback mode when power is turned on.
1 Press and hold HOME MENU for one
second.
The screen displays the ADV. SETUP menu.
2 Use the (cursor down) button to
select POWER ON START.
3 Use the / (cursor left/right) buttons
to select a mode other than OFF,
then press ENTER.
• When OFF is selected, the Power On Start
function is disabled.
4 Use the / (cursor up/down) buttons
to select 1, 2, or 3, then press ENTER.