Filter
Top Products
61
10Barcode Stack / Command Stack
Merge Groups
1 Use the / (cursor up/down) buttons
to select the next available step.
.
• The group divider (***) appears here.
Group
001
Group
002
001 02:000150-002050
002 06:22-23 * * *
003
004
005
006
007
008
Command Stack
Group
(1-002)
Command
(1-002)
Move Select ENTER CLEARDelete Exit
HOME MENU
2 Press ENTER.
3 Use the / (cursor up/down) buttons
to select “COMMAND” then press ENTER.
Group
001
Group
002
001 02:000150-002050
002 06:22-23 * * *
003
004
005
006
007
008
Command Stack
Group
(1-002)
Command
(1-002)
Move Select ENTER Exit
HOME MENU
RETURN
Return
SEGMENT PLAY
CHAPTER PLAY
COMMAND
4 Use the / (cursor up/down) buttons
to select “MERGE GROUP.”
Group
001
Group
002
001 02:000150-002050
002 06:22-23 * * *
003
004
005
006
007
008
Command Stack
Group
(1-002)
Command
(1-002)
Move Select ENTER Exit
HOME MENU
RETURN
Return
PLAY PAUSE
STEP REV
WAIT
REPEAT GROUP
GO TO GROUP
DIVIDE GROUP
MERGE GROUP
STOP
STEP FWD
000
sec.
000
5 Press ENTER.
Group
001 001 02:000150-002050
002 06:22-23 * * *
003
PLAY
004 03:123000-129000
005 05:03-07 03 2 1
006
007
008
Command Stack
Group
(1-001)
Command
(1-005)
Move Select ENTER Exit
HOME MENU
RETURN
Return
• The group divider is erased and the
previous group is joined with the following
group.
• The group number isadjusted for each
subsequent group.
.
6 Save the change.
• Merges are only saved when OK is
highlighted and ENTER is pressed
.
If “CANCEL” is highlighted when the
ENTER button is pressed, all merges
are reversed.
• If the power is interrupted while saving a
barcode stack/command stack during
video playback and the disc is still spinning,
the settings are not recorded.
.
When disconnecting the power cord, always
turn off the main power switch first (the
power indicator is not lit) or use the remote
control to set the unit to Standby mode (the
power indicator changes to red).
.