Filter
Top Products
12
<DRC1101>
En
OTHER USEFUL INFORMATION
Troubleshooting
If you suspect trouble, check the status of operations for the
following situations:
7 The power indicator does not light.
÷ Has the power cord been connected properly?
÷ Has the POWER switch been turned ON?
7 The PC does not properly recognize and
start up SCSI device.
÷ Before starting up the computer, did you connect all
SCSI devices then turn the power ON?
→First turn ON the power for all of the SCSI devices in
the SCSI chain then start the PC.
÷ Has the cable been connected properly?
→Connect all cables to their proper ports.
÷ Was the SCSI ID set correctly?
→Assign all SCSI devices in the SCSI chain different
IDs.
÷ Has the TERMINATION switch been set properly?
→When the DVD-R Drive is the only SCSI device or
when it is the final terminal in the SCSI daisy chain,
set the TERMINATION switch to “ON”.
÷ Has an appropriate software device driver been installed
for the combination of the DVD-R Drive and the
computer?
If abnormalities persist, please contact your after-sales
services representative or your sales dealer.
Routine Upkeep
Wipe the cabinet and all surfaces with a dry, soft cloth. If the
dust is substantial, soak a soft cloth in a neutral cleanser
diluted 5 to 6 times with water and wring it out thoroughly.
Wipe away any dirt. Then, use a dry cloth to wipe off any
remaining moisture.
Do not use benzene, thinner, insecticide or any other volatile
substance that could damage the surface of the device. In
addition, if using a chemical cleaning cloth, make sure to
thoroughly read the usage cautions first.
DVD-R Discs
7 When data cannot be recorded or errors
occur during recording:
÷ Is the disc one that may be used with this device?
÷ Has a sufficiently large writing area been secured?
÷ Was the DVD-R finalized (made so that no more writing
is possible)?
÷ Has the disc been inserted correctly with its label side
facing up and writing side down?
÷ Is the disc dirty or scratched?
÷ Does the operation (READ/WRITE) indicator show an
error (is it blinking orange)?
→If an abnormal rise in this device’s internal temperature
is indicated, check to see whether the temperature
around the device is still within the permissible
operation range.
7 The device cannot read a disc that has been
recorded.
÷ Is the disc one that may be used with this device?
÷ Has the disc been inserted correctly with the label side
or side 1 facing up?
÷ Is an unwritten disc installed? (Note that CDs cannot be
read.)
÷ Is the disc dirty or scratched?
÷ Has the SCSI cable been properly connected to the
SCSI connector or another SCSI device?
÷ Does the operation (READ/WRITE) indicator show an
error (is it blinking orange)?
→If an abnormal rise in this device’s internal temperature
is indicated, check to see whether the temperature
around the device is still within the permissible
operation range.
÷ Has the device been installed on a level surface?
÷ It is possible that condensation has formed on the
optical components or on the disc. (Wait 1 to 2 hours
before attempting to use the device again.)
* For other issues pertaining to DVD-R disc writing,
please refer to the manual for your application software.