Filter
Top Products
8
<DRC1101>
En
AC
IN
SCSI
ID
TERMINATION
ON OFF
SCSI
CONNECTION
The power cord and SCSI cable (sold on the market) must be
connected for operation of this drive.
After connecting the cord and cable, set the TERMINATION
switch and the SCSI ID.
When connecting the cord and cable or changing connections
and settings, turn OFF the POWER switch then unplug the
power cord from the outlet.
If the computer has no SCSI connector, install a SCSI adapter
board (sold on the market).
Connecting the Power Cord
Plug the power cord into the AC inlet “AC IN” on the rear
panel.
Connecting the SCSI Cable
Use an SCSI cable that is less than 6 m long. (For a SCSI chain
connection, make sure that the total length is within 6 m.)
The SCSI cable runs between the SCSI connectors on drive’s
rear panel and the computer. This device has two SCSI
connectors, either of which may be used.
A B
Example of SCSI chain connection
Computer
SCSI cable
7 Setting the TERMINATION Switch
For a SCSI chain connection, if this device is used at
position “A”, set the TERMINATION switch to “OFF”.
When this device is used at position “B”, set the
TERMINATION switch to “ON”.
If this is the only device connected to the computer, set
the TERMINATION switch to “ON”.
TERMINATION
ON OFF
NOTE:
This switch is preset to “ON” at the factory.
Personal computer
SCSI adapter
SCSI cable
DVD-R drive
Power cord
Connect to a wall outlet.