Filter
Top Products
25
GETTING STARTED USING YOUR DVD PLAYER
1 Press STOP 7 (7 on the front panel).
Playback stops.
2 Press OPEN/CLOSE 0 (0 OPEN/CLOSE on
the front panel).
• The disc tray comes out.
• The tray rotates and the disc that was playing is
located towards the front of the table.
3 Remove the disc.
• If you want to remove more discs, press DISC
SKIP to rotate the disc tray.
4 Press ( STANDBY/ON on the front
panel).
The disc tray goes back in.
Stopping Playback and
Switching Power Off
– DVD/Video CD/CD
Resuming Playback from
Where You Stopped – DVD/Video CD
Use the resume feature to restart playback from the
point that the disc was stopped last time.
Press STOP 7 once.
The display shows “RESUME” and the stop position is
memorized.
• The resume position remains memorized as long as
the disc is in the play position — even if you switch
the power off.
If you change the disc in the play position or start
playing another disc, however, the resume position is
lost.
• Pressing STOP 7 twice causes the disc to return to
the beginning when PLAY 3 is pressed again. The
display shows the disc type (DVDs or Video CDs)
Press PLAY 3.
Playback starts from the resume position.
Notes
• The actual restart position may be slightly before or after the
resume position.
• If you want to remove or change the disc, but still want to
resume playback from the last stopped position, use the
LAST MEMORY feature instead (page 52).
CAUTION: When moving the unit
When changing places of installation or packing the unit for
moving, be sure to remove all discs and return the disc table
to its original position in the player. Then, press
STANDBY/ON and switch the power to standby. Check that
the “--OFF--” indication on the display goes off, then
disconnect the power cord. Moving this unit with the disc
loaded may result in damage to this unit.
4
3
2
1
DVD PLAYER