Filter
Top Products
60
En
Adjustments and Settings
11
No Operation off (AV source only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER).
3 Select “No Operation off” ( / then ENTER).
4 Select “Enable” ( / then ENTER).
5 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
Power Management (PC source only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER).
3 Select “Power Management” ( / then ENTER).
4 Select “Mode 1” or “Mode 2” ( / then ENTER).
5 Press HOME MENU to exit the menu.
Note
• This function is not selectable when the PC is connected to the
HDMI terminal.
Sleep Timer
When the selected time elapses, the Sleep Timer automatically
places the system into the standby mode.
• The factory default is “Off”.
1 Press HOME MENU.
2 Select “Sleep Timer” ( / then ENTER).
3 Select the desired time ( / then ENTER).
• Select “Off” (cancel), “30 min”, “60 min”, “90 min” or “120 min”.
4 Press HOME MENU to exit the menu.
Note
• Five minutes before the selected time elapses, the remaining
time appears every minute.
• To check the remaining time, perform steps 1 and 2. After
checking the time, press HOME MENU to restore the previous
display.
• The SLEEP indicator on the front of the plasma display lights
orange when the sleep timer is set.
About “Option” menus
The “Option” menu consists of two screens. To select the desired
menu, press / repeatedly to switch between Screen 1 and
Screen 2. The current screen number appears at the top right
corner on the screen.
Item Description
Disable
(default)
Does not place the system into the standby mode
Enable Places the system into the standby mode if no
operation is performed for three hours
Item Description
Off
(default)
No power management
Mode 1 •Places the system into the standby mode when no
signal is received from the personal computer for
eight minutes.
•Even when you start using the computer and a
signal is received again, the system stays off.
•The system is switched on again by pressing
STANDBY/ON on the plasma display or TV on
the remote control unit.
Mode 2 •Places the system into the standby mode when no
signal is received for eight seconds.
•When you start using the computer and a signal is
received again, the system is switched on.
•The system is switched on again by pressing
STANDBY/ON on the plasma display or TV on
the remote control unit.
Option
Position
Auto Size
Side Mask
HDMI Input
HDMI Control Setting
Blue LED Dimmer
Orbiter
Video Pattern
1/2
Auto
On
Wide-Zoom
Option
Digital Audio Out
Language
Tuner NR Setting
Game Control Pref
Room Light Sensor
2/2
On
Off
Dolby Digital
(For AV source)
PRO1150HD.book Page 60 Tuesday, April 17, 2007 9:34 AM