Filter
Top Products
70
En
Enjoying through External Equipment
12
Connecting control cords
Connect control cords between the plasma display and other
Pioneer equipment having the logo. You can then operate the
connected equipment by sending commands from its remote
control unit to the remote control sensor on the plasma display.
After the CONTROL IN terminals have been connected, the
remote control sensors on the connected equipment do not
accept commands from the remote control units. Face the
remote control units to the remote control sensor on the plasma
display when operating the connected equipment.
Note
• Make sure that the power is turned off when making
connections.
• Complete all component connections before making control
cord connections.
About SR+
The CONTROL OUT terminal on the rear of the plasma display
supports SR+, which allows linked operations with a Pioneer AV
receiver. SR+ presents functions such as the input switch linkage
operation function and the DSP surround mode display function.
For more information, see the instruction manual that came with
the Pioneer AV receiver supporting SR+.
Note
• When making control cord connections, use the SR+ cable.
• When making control cord connections with one or more
pieces of Pioneer equipment, directly connect the plasma
display and the Pioneer amplifier that supports SR+. Do not
connect other equipment between them.
• When the connected equipment is being operated using SR+,
the volume on the plasma display is temporarily reduced.
IR REPEATER OUT
Connect control cords between the plasma display and other
Pioneer equipment. You can then operate the connected
equipment by sending commands from its remote control unit to
the remote control sensor on the plasma display. This function is
convenient when controlling Pioneer equipment from other
Pioneer equipment.
Plasma display
Rear view
a
b
c
4 5
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
When
SR+
is not used (
a
,
b
, and
c
):
The control cables (commercially
available) are mono sound cables with
mini plugs (no resistance).
When
SR+
is used (
a
):
Use the
SR+
cable (available as option).
PRO1150HD.book Page 70 Tuesday, April 17, 2007 9:34 AM