Filter
Top Products
16
PRO-1000HDI / PRO-800HDI
Power Cord Connection
Connect the power cord after all component connections
have been completed.
1 Connect the power cord to this unit.
2 Plug the power cord into a power outlet.
CAUTION
÷ Use only the power cord provided.
÷ Do not use a power supply voltage other than that indicated
(AC 120 V, 60 Hz) as this may cause fire or electric shock.
÷ For the plasma display, a three-core power cord with a ground
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged grounded outlet
and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground
terminal and screw down the ground line.
Installation and Connections
1
2
Control Cord Connection
When control cord connections are made, remote control
operation of connected PIONEER components that bear
the Î logo mark is done through the remote sensor on
this unit.
When the connection is made to the CONTROL IN
terminal on another unit, the remote sensor of that
component will no longer receive signals. Point the
remote control unit of the connected component at the
remote control sensor on this unit to control.
Notes
÷ Make sure the power is turned off when making
connections.
÷ Please complete all component connections before
making control cord connections.
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
IN OUT
CONTROL
The control cables (not
supplied) are monaural
cables with mini plugs (no
resistance).
Main unit