Filter
Top Products
The Initial Setup menu 16
149
En
Audio Output Auto •
Dolby Digital, MPEG and DTS sources are output as
a bitstream signal. However, depending on the
Audio Out
setting, number of audio channels, and
the HDMI-connected device, Linear PCM audio may
be output.
PCM
All audio signals are converted to Linear PCM
(except DTS).
Bitstream Priority
Select if the connected device is compatible with bit-
stream audio.
This setting is not available when a DVI device is connected
.
Video Priority Mode HDMI •
Select for high quality picture output on a connected
HDMI display. However, on this setting the YNR and
Detail picture quality settings are not effective for
analog video, and component video will be set to
interlaced.
Component
Select if you want the YNR and Detail picture quality
settings to be effective for both HDMI and analog
video output, or if
Component Video Out
is set to
Progressive
while an HDMI display is connected
(page 141).
When watching video on an HDMI display, use the
HDMI
setting.
Options
On Screen Display On •
The recorder displays operation displays (
Stop
,
Play
,
etc.) on-screen.
Off
Switches off the on-screen operation displays.
Front Panel Display On •
The time is shown in the front panel display when the
recorder is in standby.
Off
The front panel display is switched off in standby
(although it still lights dimly when setting a timer
recording).
Remote Control
Mode
Recorder 1–3
(default: Recorder 1)
If you are using more than one recorder in the same
room, set them to different IDs. This setting sets the
recorder ID; to change the remote controller ID,
press and hold
RETURN/EXIT
then press
1
,
2
or
3
to
set. The remote will only control a recorder with the
same ID.
Setting
Options Explanation
DVR940HX_UK_EN.book 149 ページ ２００６年７月１２日 水曜日 午後４時５分