PYLE Audio DVR-940HX-S DVD Recorder User Manual


 
Using the GUIDE Plus+® electronic program guide 05
55
En
About timer recording
Using the timer recording features you can
program up to 32 timer recordings up to a
month in advance. Timer recording
programs can be set to record just once,
every day, or every week.
You can set the recording quality for your
timer recording in the same way as for a
regular recording, but with the added option
of an
AUTO
mode, which maximizes the
recording quality for the space available on
the disc (if recording to DVD), or to fit on to a
blank DVD disc (if recording to the (internal)
HDD).
You can set timer recordings to record to a
recordable DVD or to the hard disk drive. For
regular (daily or weekly) HDD timer
recordings that you don’t need to keep, you
can use the Auto Replace Recording
feature
1
to automatically replace the
previous timer recording with the new one.
Note that when you use this feature, the
previous recording made on that timer
program will be replaced by the next one,
regardless of whether you have watched it
yet or not.
You can also set the recorder so that it will
adjust the recording quality to try and fit the
recording on to the disc if it would not
otherwise fit at the recording quality you set
(see
Optimized Rec
on page 145 for more on
this).
Finally, if you set a timer recording to record
to DVD but there isn’t a recordable DVD
loaded at the time of the recording, the
Recovery Recording feature will
automatically record the program to the
HDD for you.
DVR-940HX-S:
If the recording
destination is the external HDD but at the
time of recording the external HDD is not
connected, the internal HDD will be used for
the recording. During high-speed copying,
the recording destination may also be
changed automatically.
This recorder is compatible with VPS (Video
Programming System) and PDC (Program
Delivery Control) systems used by many
analog TV stations to ensure that a timer
recording catches the whole program even
when the program is not running to
schedule. Up to eight timer programs can be
set with VPS/PDC on.
Important
•A timer recording can’t be set if there are
already 32 timer programs waiting to be
recorded.
Timer recording will not start if:
– The recorder is already recording.
– A disc is being initialized, finalized or
unfinalized.
Timer recording will start when the
operation preventing timer recording
has finished.
The timer indicator ( ) lights in the front
panel display when the timer is active. If
the indicator is blinking it means that
(for a DVD timer recording) there is no
disc loaded, or the disc loaded is not
recordable (for an HDD timer recording
it means that the HDD is not recordable).
DVR-940HX-S:
If the timer is set to record
to the external HDD, but the external
HDD is not recordable, the timer
indicator does not blink to warn of this.
Approximately two minutes before a
timer recording is set to start, the
recorder will go into timer recording
standby. In timer recording standby you
cannot use some functions.
The maximum length for timer
recordings made to the HDD is 24 hours.
However, because one title (HDD) is
limited to 12 hours, recordings over 12
hours will be spread over two titles. Note
that there will be a break in the recording
of a few seconds between titles.
Note
1
DVR-940HX-S:
Auto Replace Recording is always to the internal HDD (HDD1).
DVR940HX_UK_EN.book 55 ページ 2006年7月12日 水曜日 午後4時5分