Filter
Top Products
Connecting up 02
19
En
Connecting to a cable box or
satellite receiver
If you have a cable box or satellite receiver
with a built-in decoder, connect it to this
recorder and your TV as shown on the
following page.
1
If you are using a separate
decoder box for your cable/satellite TV, set
up following the instructions on the next
page.
Using the setup on this page you can:
• Record any channel by selecting it on
the cable box, satellite receiver or digital
terrestrial receiver.
• Change channels and set timer
recordings on the external receiver using
the GUIDE Plus+
®
system (via the
G-LINK™ cable, and after setting up).
Important
• Do not connect this recorder to your TV
‘through’ your VCR, satellite receiver or
other component. Always connect each
component directly to your TV or AV
amplifier/receiver.
• When using the GUIDE Plus+ system to
make a timer recording from an external
receiver, make sure that the external
receiver is switched on.
1 Connect RF antenna cables as shown.
See
Connecting a TV antenna
on page 16 for
more on RF antenna connections, including
from this recorder to your TV.
2 Use a SCART cable (not supplied) to
connect the AV1(RGB)-TV AV connector
to a SCART AV connector on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect
the AV2(INPUT 1/DECODER) AV
connector to a SCART AV connector on
your cable box/satellite receiver.
This enables you to record scrambled TV
channels.
Note
1 The diagram shows SCART video connections, but you can alternatively use any of the other audio/video con-
nections.
TV
Satellite dish/
antenna/cable TV
wall outlet
Cable/Satellite
receiver
To recorder's
antenna input
HDMI
OUT
ANTENNA
IN
OUT
DIGITAL
AUDIO OUT
COAXIAL
ANTENNA
(DIGITAL)
IN
OUT
VIDEO
L
R
COMPONENT
VIDEO OUT
S-VIDEO
OUTPUT
INPUT3
IN
CONTROL
G-LINK
AV 1 (RGB) – TV
AV 2 (INPUT 1/DECODER)
AC IN
COMMON INTERFACE
AUDIO
P
B
P
R
Y
SCART AV
CONNECTOR
SCART AV
CONNECTOR
ANTENNA
OUT
ANTENNA
IN
1
2
3
4
DVR940HX_UK_EN.book 19 ページ ２００６年７月１２日 水曜日 午後４時５分