Filter
Top Products
30
2. Repeatedly press
SPEED
on the remote
control until the desired recording speed
(
SP
,
LP
, or
SLP
) appears on the TV screen.
3. Press
CH
or
CH
or use the remote
control’s number buttons to select the
desired channel.
4. Press
REC/OTR
twice on the front of the
Model 28 to begin recording. The REC indi-
cator on the Model 28 turns on,
OTR
and
(0:30)
appear on the TV screen for
about 5 seconds, and the Model 28 records
what you see on the TV screen.
To change the displayed total recording
time, within 5 seconds repeatedly press
REC/OTR
to advance the time in 30-minute
increments.
Note:
If you do not press
REC/OTR
within 5
seconds, the recording time disappears.
Simply press
REC/OTR
again to redisplay
the remaining recording time.
When you finish entering all OTR informa-
tion, the displayed information disappears
after 5 seconds.
OTR Hints
• To ensure that you record all of the desired
program, you might want to set the record-
ing stop time 30 minutes later than the
scheduled end of the program.
• You can program OTR information only
while a tape is recording. You cannot pro-
gram OTR information if a tape is not
inserted in the Model 28, if the erase-
protection tab on the tape is removed, or if
automatic timer recording is in progress.
• During OTR recording, the remaining
recording time is displayed on the TV
screen for 5 seconds.
• When the recording stop time is reached
during OTR recording, the Model 28 turns
off.
• To turn off the TV screen while recording,
press
MONITOR
.
• You can check automatic program timer
settings during OTR. See “Automatic Timer
Recording (Timer Numbers 1-7)” on this
page.
• Be sure the tape length you select for OTR
is long enough to record the entire pro-
gram. Even though you can set the Model
28 to record for up to 8 hours, the actual
recording time is limited by the tape’s
length.
• To cancel OTR while the Model 28 is
recording, press
STOP/EJECT
on the Model
28 (or
STOP
on the remote control).
AUTOMATIC TIMER
RECORDING (TIMER
NUMBERS 1-7)
You can program the Model 28’s automatic tim-
er to select a channel, start recording a broad-
cast on that channel at a time and tape speed
you set, then stop recording at a time you set.
You can set up to 7 automatic program timers to
record any combination of weekly, daily, or one-
time broadcasts on the same or different chan-
nels.
You can set up the Model 28 to record at any
time on a specific day you set within a 1-year pe-
riod (ONCE), any time at the same time Monday
through Friday (DAILY), and any time the same
day every week (WEEKLY).
Note:
You cannot set an automatic timer record-
ing while you are recording a program.
SP
16-420.fm Page 30 Tuesday, July 20, 1999 11:32 AM