Filter
Top Products
36
Dubbing a Tape
Note:
For the best results while dubbing, hold
the remote control close to the Model 28’s infra-
red window when you press a button. Other-
wise, the remote control might affect the
dubbing source’s operation.
1. Prepare the dubbing source.
2. Insert a blank cassette, or one that you
want to record over, into the Model 28’s
cassette compartment. The Model 28 turns
on.
3. Enter
00
using the remote control’s number
buttons, or press
CHANNEL
or
CHAN-
NEL
to select one channel higher than
the highest programmed channel or one
channel lower than the lowest programmed
channel.
AUX
appears on the Model 28’s
TV screen.
4. Repeatedly press
SPEED
on the remote
control until the desired recording speed
(
SP
,
LP
, or
SLP
) appears.
5. Press
REC/OTR
on the Model 28 or
RECORD
on the remote control
to begin
recording.
6. Start the dubbing source.
7. To turn off the Model 28’s TV screen, press
MONITOR
.
8. Press
STOP
on the remote control or
STOP/
EJECT
on the front of the Model 28 to stop
recording before it automatically stops at
the end of the tape. Then stop the dubbing
source.
16-420.fm Page 36 Tuesday, July 20, 1999 11:32 AM