Filter
Top Products
17
Changing the Channels Stored in
Memory
Although the Model 36 automatically stores all
active channels in your area the first time you
turn it on, you can manually set the Model 36 to
re-program the tuner’s memory.
Note:
If you tune both TV (broadcast) and CATV
(cable TV) signals, you can store both types of
channels.
1. Press
MENU
to select the main menu.
2. Press
PLAY/
s
or
STOP/
t
to select
CHANNEL
SET
UP
, then press
F.FWD/
. The channel
set up menu appears.
3. Press
PLAY/
s
or
STOP/
t
to select
AUTO
PRESET
, then press
F.FWD/
.
The Model
36’s tuner scans through the channels (TV
or CATV) and stores all the active channels
in your area.
CH
and the currently tuned
channel number appear. After scanning all
the channels, the tuner stops on the lowest-
numbered active channel.
4. To review the stored channels, repeatedly
press
CHANNEL
s or t.
Note:
You can directly select channels that are
not stored in the tuner’s memory by using the re-
mote control’s number buttons. See “Selecting
Channels” on Page 20.
Adding/Erasing Channels
If a channel you want was not stored, or if a
channel you do not want was stored, follow
these steps to add or erase it.
1. Press
MENU
to select the main menu.
2. Press
PLAY/
s
or
STOP/
t to select
CHANNEL
SET
UP
, then press
F.FWD/
. The channel
set up menu appears.
3. Press
PLAY/
s
or
STOP/
t to select
ADD/
DELETE
CH
,
then press
F.FWD/
.
4. Press
CHANNEL
s or t or use the number
keys on the remote control to enter the
channel number you want to add or erase.
Note:
Precede a single-digit number with a
0 — for example,
01
,
02
, and so on.
5. Repeatedly press
F.FWD/
or
REW/
until the channel number for the channel
changes to blue (to add the channel) or to
red (to delete the channel).
6. Press
MENU
to exit.
SELECTING THE INPUT SIGNAL
Depending on the type of input device (antenna
or cable) connected to your Model 36, you must
select the input signal (the source you want the
Model 36 to tune).
1. Press
MENU
to select the main menu.
2. Press
PLAY/
s
or
STOP/
t to select
CHANNEL
SET
UP
, then press
F. FW D/
. The channel
set up menu appears.
3. Repeatedly press
F.FWD/
or
REW/
to
select the desired input signal (
TV
or
CATV
).
• If you connected an antenna (not cable)
to the Model 36 and want to receive up to
68 VHF/UHF channels, or if you have
cable service and use a cable box, you
must select
TV
.
• If you have cable service and do not use
a cable box, you must select
CATV
.
4. Press
MENU
to exit the menu.
08
ADD / DELETE
– CHANNEL SET UP –
TV/CATV [TV]
AUTO PRESET
ADD / DELETE CH
16-429.fm Page 17 Tuesday, July 20, 1999 3:50 PM